Width of cut:  60 inches

Blade holder: 1 inch thick T-1 Steel with six positions

Deck:  ¼ inch thick reinforced top and wide ½ inch thick sides

Guarding:  Chains on front and belt on rear

Skids: 3/8 x 2-1/2 thick full length T-1 steel

Operating rpm is 1250

Direct drive spindle is made of heat treated 4140 tool steel and is 7.5 inches od, has a 2-5/8 inch top bearing and a 3-5/8 inch bottom bearing

Deck operating range is 90 degrees up and 45 degrees down.

Cast iron gear type motor

Lift cylinder is 3 x 10 tie rod 3000 psi rated cylinder

Tilt cylinder is 3 x 10 tie rod 3000 psi rated cylinder